what type of bit do I need to remove rivets on a haulmark?

P4PLABS

I can't seem to figure out the bit type that will fir the rivets in my trailer. Ive tried t20 and it just isn't exacty what I need.....what the heck are they?

Horker23 · Posted: Sun Nov 15, 2009 7:03 am Post subject:

I just use a square bit that fits in. For some reason none of the T-wreches fit the screws!

Jungda99 · Posted: Sun Nov 15, 2009 9:46 am Post subject:

I had the same problem. I drove to every store in town to try and find the correct drill bit. Never did find one. I finally had to "easy out" them.

P4PLABS · Posted: Mon Nov 16, 2009 8:48 am Post subject:

For anyone else having this problem and looking for the easiest way. It is a #2 square bit and haulmark even recommends it.